----------------------------------------------------------------------------------
@MSGID: 3:633/10 491660f1
@PID: PyGate 1.5.19
@TID: PyGate/Linux 1.5.19
@NOTE: Mozilla Thunderbird
@CHRS: ASCII 1
@TZUTC: 0200
@REPLYADDR: mm@dorfdsl.de
@REPLYTO: 3:633/10 UUCP
@RFC-Message-ID: <11avrbm$1jbda$1@solani.org>
Hello!
I have a RPi 4B. I used it with Debian in the past, now I want to use
FreeBSD 15.1. I extracted the .xz file and wrote the .img to the disk,
the 2 partitions are there.
Although, I only see the rainbow bootscreen.
Now someone suggested that I should look at the serial output.
I connected a TTL to USB adapter. Does this already give output during
the boot process (with or without the OS loaded)?
I used this adapter successfully at a Switch, so it is operational, but
I need to know which speed/duplex settings the RPi requires during the
boot process.
Thanks for any suggestions.
--
kind regards
Marco
Spam bitte an
abfalleimer2001@stinkedores.dorfdsl.de
--- PyGate Linux v1.5.19
* Origin: Dragon`s Lair, PyGate NNTP<>Fido Gate (3:633/10)
SEEN-BY: 19/10 50/109 153/757 218/840 840 220/70 221/1 6 360 226/17 100
SEEN-BY: 229/426 240/1120 267/800 301/1 113 812 310/31 335/364 341/66 463/68
SEEN-BY: 550/278 633/10 280 281 416 418 420 422 509 2744 712/848 770/1 3 100
SEEN-BY: 770/340 772/210 220 230 5001/100 5019/40 5020/715 848 1042 4441 12000
SEEN-BY: 5023/24 5030/49 722 1081 1474 5051/44 5061/133 5075/128
@PATH: 633/10 280 770/1 218/840 221/6 301/1 5020/1042 4441 715