----------------------------------------------------------------------------------
@MSGID: 3:633/10 738eef07
@REPLY: 3:633/10 9a5c77f0
@PID: PyGate 1.5.19
@TID: PyGate/Linux 1.5.19
@NOTE: tin/1.8.3-20070201 ("Scotasay") (UNIX) (Linux/5.10.0-44-amd64 (x86_64))
@CHRS: ASCII 1
@TZUTC: 0100
@REPLYADDR: theom+news@chiark.greenend.org.uk
@REPLYTO: 3:633/10 UUCP
@RFC-Message-ID: hzYTA@news.chiark.greenend.org.uk>
Marco Moock <
mm@dorfdsl.de> wrote:
> Thanks for the link.
> I need to figure out how I can read and set the OTGID in FreeBSD.
It`s a physical 5th pin on the micro USB connector. If you insert a normal
A male (host) to microUSB male (device) cable the cable grounds the pin. If
you insert an OTG cable (microUSB to A female, so the Pi becomes the host)
the pin is left floating.
So if you use an `OTG` cable the port will be put into `host` mode, if you
connect it to a PC with a regular micro USB cable the port will be in
`device` mode.
You can override this with some dwc2 settings in config.txt.
Theo
--- PyGate Linux v1.5.19
* Origin: Dragon`s Lair, PyGate NNTP<>Fido Gate (3:633/10)
SEEN-BY: 19/10 50/109 153/757 218/840 840 220/70 221/1 6 360 226/17 100
SEEN-BY: 229/426 240/1120 267/800 301/1 113 812 310/31 335/364 341/66 463/68
SEEN-BY: 550/278 633/10 280 281 416 418 420 422 509 2744 712/848 770/1 3 100
SEEN-BY: 770/340 772/210 220 230 5001/100 5020/715 848 1042 4441 12000 5023/24
SEEN-BY: 5030/49 722 1081 1474 5051/44 5061/133 5075/128
@PATH: 633/10 280 770/1 218/840 221/6 301/1 5020/1042 4441 715