Nп/п : 25 из 100
 От   : Leon                                2:5075/128        01 авг 23 12:45:12
 К    : DerbyDad03                                            01 авг 23 20:51:09
 Тема : Re: Ping Leon: Kitchen Question
----------------------------------------------------------------------------------
                                                                                 
@MSGID: <PumcnXLs_eU12VT5nZ2dnZfqn_SdnZ2d@giganews.com>
815ab2b6
@REPLY:
<251ac92a-ea68-4372-8455-d7d3f54e4575n@googlegroups.com> 40a7e7b5
@REPLYADDR Leon <lcb11211@swbell.net>
@REPLYTO 2:5075/128 Leon
@CHRS: CP866 2
@RFC: 1 0
@RFC-References:
<251ac92a-ea68-4372-8455-d7d3f54e4575n@googlegroups.com>
@RFC-Message-ID:
<PumcnXLs_eU12VT5nZ2dnZfqn_SdnZ2d@giganews.com>
@TZUTC: -0500
@PID: Mozilla/5.0 (Windows NT 10.0; Win64; x64;
rv:102.0) Gecko/20100101 Thunderbird/102.13.0
@TID: FIDOGATE-5.12-ge4e8b94
On 7/28/2023 1:31 PM, DerbyDad03 wrote:
> Please refer to this picture of your kitchen:

https://flickr.com/photos/lcb11211/52918531079/in/datetaken/

> I`d like to know these 2 measurements:

> 1 -The distance from the front the counter top to the front of the range.
> 2 - The difference in the height of the counter vs. the height of the
> side of the range, specifically the section near the red pot cover.

> We`re going to be doing something similar (slide-in range with countertop
 > on both sides) and I will be building two base cabinets. I`m
assuming that your installation is "standard" so knowing the difference in
depths will
> will help me determine the depth of my countertop and therefore the
> depth on the base cabinet. We`re going to the countertop fabricator this
> week and I need to account for those two pieces in the layout.

 > Obviously, I don`t need the height for the fabricator, but am I
curious as to what was used in your kitchen.

> Thanks!

>   

>    

1.   Front of the Counter top to the front of the range control console, 
2.25"  To the front of the oven door handle approximately 2.75"

https://flickr.com/photos/lcb11211/53087293998/in/datetaken/

2.  The back area of the range top is approximately 1/4" higher than the 
counter top.  Closer to the front of the range the difference is closer 
to 3/8"  If we have a spill we want it to go towards the back of the 
cook top.

FWIW I matched the height of the existing bottom cabinets, the 2 that we 
reused, for the new cabinets.  The quartz is 3 cm thick.
 --- Mozilla/5.0 (Windows NT 10.0; Win64; x64; rv:102.0) Gecko/20100101
Thunderbird/102.13.0
 * Origin: usenet.network (2:5075/128)
SEEN-BY: 5001/100 5005/49 5015/255 5019/40 5020/715
848 1042 4441 12000
SEEN-BY: 5030/49 1081 5058/104 5075/128
@PATH: 5075/128 5020/1042 4441



   GoldED+ VK   │                                                 │   09:55:30    
                                                                                
В этой области больше нет сообщений.

Остаться здесь
Перейти к списку сообщений
Перейти к списку эх